Pipe Handlers 161-9 Series
- For use as a Pipe Handler, Grapple, and many material handling requirements
- Manufactured to the customer’s requirements
- Inflate with air, inert gas or water
- Lift, pull, and align tubes, pipes, transformers, and many handling requirements
- Most weight, temperature, and chemical requirements
- They are not to be used for lifting over any personnel or where their failure would cause significant damage
- Many configurations available
Call or send an email to let us quote a pipe handling equipment that meets your specific requirements. Provide:
- Lift Load
- Internal Diameter
- Length Available
- Pipe or cylinder material
- Special chemical or temperature requirements
- Inflatable Lift Cylinder Warning: NEVER lift a load over a person or an object that could be damaged if the load is lost for any reason. NEVER inflate with a pressure greater than the Lifting Cylinder rating or the capacity of the cylinder being lifted. The Lift Cylinder pressure rating assumes it will be supported on the entire inflated length. Maximum inflation pressure and lift loads are only estimates and slippage may be influenced by many factors including wet surfaces, coefficient friction, accuracy of pressure gauges, etc. The inflation pressure must be tested on the actual load.
